Samsung 9C8 (2024)

FAQs

How do you reset the error code on a Samsung washing machine? ›

Press the 'Power' for 5 seconds, then wait 10 seconds, and press the 'Start/Pause' buttons for 5 seconds as well. Wait 5 minutes, to allow for all residual electricity to discharge from your washer. Plug your washer back in, and turn it on. Run a test cycle to ensure the washer works properly.

Hold the Smart Control button for 3 seconds and then the Temp button for 7 seconds. Turn the machine off and back on. These steps should help resolve the 9C8 error code on your Samsung washing machine unless it is a software issue which usually will require repairs.

Enter the code *2767*3855# or *2767*2878# and hit the call button. You will see a warning pop-up; click Yes to proceed. Your Samsung phone will start the factory reset process.

##4636##: This code opens the diagnostic and general settings mode, which provides access to various device information and settings.

If your washing machine displays the code "UE", try redistributing the load by adding or removing items to ensure a more balanced load. Single large or heavy items such as bath mats or large towels are unlikely to spin on their own, so try adding two or three additional towels and then restart the spin cycle.

If you put too many clothes in the drum and overload the machine it may result in error code E08 being displayed. Should this occur then reduce the load size by removing some of the garments in the drum and try again. Should the error persist please call one of our advisors for further assistance.

Switch off the appliance at the mains then wait 30 seconds. Switch the appliance back on again and start a new program. If the information code remains, contact a customer service center. Operating the washing machine with the lid open.

There really isn't a way to reset the washing machine. What you can do instead is power cycle it: Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the washer (usually 1 to 5 minutes at most), and then power it up again.

9C1 or UC Error is related to the excessive fluctuation of the power supply voltage. You may do the following to check and fix the issue: Switch off the washing machine and unplug the power cable from the power source and power it on again and start a new washing program again.

The P0750 code indicates that the shift solenoid, which is one of the devices that controls the flow of transmission fluid within the unit, has malfunctioned in some way.

What is the code for EVAP leak? ›

The P0455 diagnostic trouble code appears when there's a leak in the Evaporative Emission Control (EVAP) system, and the system can't maintain pressure. The EVAP system usually consists of five main components: the fuel tank, fuel cap, vent valve, purge valve, and the evaporative canister (or charcoal canister).

First though, it's possible that if you power cycle the microwave, you may clear the error. And if you think moisture may have gotten in the microwave, that could be causing errors too, so let it dry. If you receive an error code: Unplug the microwave or turn it off at the circuit breaker.